ABS (Anti-Lock Brake System)
4-52
7. Check:
● Hydraulic unit operation
When the main switch is set to “ON”, the ABS
warning light comes on for 2 seconds, goes
off for 3 seconds, then starts flashing. When
the ABS warning light starts flashing, the front
brake lever “1” will return to its home position.
The rear brake lever “2” will then return to its
home position, then the front brake lever will
return to its home position again.
CAUTION:
ECA15B1011
● Check that the front brake lever returns to
its home position before the rear brake le-
ver returns to its home position.
● If the rear brake lever returns to its home
position before the front brake lever does,
check that the brake hoses are connected
correctly to the hydraulic unit.
● If either the brake levers returns to its home
position slowly, check that the brake hoses
are connected correctly to the hydraulic
unit.
● If the operation of the hydraulic unit is normal,
delete all of the malfunction codes.
EAS22820
TRIAL RUN
After all checks and services are completed, al-
ways ensure the vehicle has no problems by
performing the trial running at a speed of faster
than 10 km/h.
1
2
To Next Page
Loading...
