Name: Dell PowerConnect 6224
Brand: Dell
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Configuring Dell PowerConnect 111

Device Default Settings

To return to device default settings use delete startup-config command at the privileged

mode prompt (#), and reboot the device. Once device reloads – it is set with the default settings.

console>

console>enable

console#delete startup-config

Startup file was deleted

console#reload

Management switch has unsaved changes.

Are you sure you want to continue? (y/n) y

Configuration Not Saved!

Are you sure you want to reload the stack? (y/n) y

Reloading all switches..

Enabling Remote Management

Enter the

enable

command at the console to enter the Privileged EXEC screen mode as follows:

console>enable

console#

Connect the management station to the switch through one of the Ethernet ports, or through a

network connected to the switch, using a CAT5 Cable.

This example uses port

1/xg1

Ensure (on the serial console) that the interface status changed to “up” and that the STP status is

forwarding (after 30 seconds), as shown below:

console#

01-Jan-2000 01:43:03 %LINK-I-Up: Vlan 1

01-Jan-2000 01:43:03 %LINK-I-Up: 1/xg1

01-Jan-2000 01:43:34 %STP-I-PORTSTATUS: Port 1/xg1: STP status

Forwarding

Other manuals for Dell PowerConnect 6224

Questions and Answers:

Need help?

Do you have a question about the Dell PowerConnect 6224 and is the answer not in the manual?

General