Dell PowerConnect 6224 User Manual

Configuring Switching Information 389
– Source/Destination MAC, VLAN, EtherType, source MODID/port
– Source/Destination IP and source/destination TCP/UDP port
Configuring the LAG Hash
1. Open the LAG Hash Configuration page.
2. Select the LAG to configure and the hash algorithm to assign to the LAG.
3. Click Apply Changes .
The parameters are modified, and the device is updated.
Configuring the LAG Hash Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• Port Channel Commands
The following table summarizes the equivalent CLI commands for this feature.
LAG Hash Summary
The LAG Hash Summary page lists the channels on the system and their assigned hash algorithm type.
To display the LAG Hash Summary page, click Switching
→ Link Aggregation → LAG Hash Summary in
the tree view.
Table 7-36. LAG Hash Commands
CLI Command Description
hashing-mode Sets the hashing algorithm on trunk ports.
no hashing-mode Sets the hashing algorithm on trunk ports to default (3).

Dell PowerConnect 6224 Specifications

General

Brand	Dell
Model	PowerConnect 6224
Category	Switch
Language	English