Dell PowerConnect 6224 User Manual

460 Configuring Switching Information
Figure 7-125. DHCP Relay Global Configuration
If you enable or disable the DHCP Relay feature, click Apply Changes to submit the changes to system.
Configuring DHCP Relay With CLI Commands
For information about the CLI commands that perform this function, refer to the following chapter in
the
CLI Reference Guide :
• L2 DHCP Relay Agent Commands
The following table summarizes the equivalent CLI commands for this feature.
DHCP Relay Interface Configuration
Use this page to enable L2 DHCP relay on individual ports.
NOTE: L2 DHCP relay must also be enabled globally on the switch.
To access this page, click Switching → DHCP Relay → Interface Configuration in the tree view.
Table 7-72. DHCP Relay Global Commands
CLI Command Description
dhcp l2relay Enables the Layer 2 DHCP Relay agent for an interface.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)