Dell PowerConnect 6224 User Manual

612 Configuring IPv6
Interface Configuration
Use the Interface Configuration page to configure IPv6 interface parameters. This page has been
updated to include the IPv6 Destination Unreachables field.
To display the page, click IPv6
→ Interface Configuration in the tree view.
Figure 10-2. IPv6 Interface Configuration
The IPv6 Interface Configuration page contains the following fields:
• Interface — Selects the interface to be configured. When the selection is changed, a screen refresh
occurs, causing all fields to be updated for the newly selected interface. Shows only routing-enabled
interfaces and tunnels.
•
IPv6 Mode — When IPv6 mode is enabled, interface is capable of IPv6 operation without a global
address. In this case, an EUI-64 based link-local address is used. This selector lists the two options for
IPv6 mode:
Enable and Disable . Default value is Disable .

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)