Dell PowerConnect 6224 User Manual

234 Configuring System Information
Removing a Filter
1. Open the Notification Filter page.
2. Click Show All .
The
Show Notification page displays.
3. Select the Filter Table entry.
4. Check Remove .
The filter entry is removed, and the device is updated.
Configuring Notification Filters Using CLI Commands
For information about the CLI commands that perform this function, see the SNMP Commands chapter
in the
CLI Reference Guide . The following table summarizes the equivalent CLI commands you use to
configure notification filters.
Notification Recipients
Use the Notification Recipients page to view information for defining filters that determine whether
traps are sent to specific users, and the trap type sent. SNMP notification filters provide the following
services:
• Identifying Management Trap Targets
•Trap Filtering
• Selecting Trap Generation Parameters
• Providing Access Control Checks
To display the Notification Recipients page, click System → SNMP → Notification Recipient in the tree
view.
Table 6-45. Notification Filters Configuration Commands
CLI Command Description
show snmp filters Displays the configuration of filters.
snmp-server filter Creates or updates an SNMP server filter entry.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)