392 Configuring Switching Information
The Multicast Global Parameters page contains the following field:
•
Bridge Multicast Filtering
— Enables or disables bridge Multicast filtering. The default value is
disabled.
•
IGMP Snooping Status
— Enables or disables IGMP snooping. The default value is disabled.
•
MLD Snooping Status
— Enables or disables MLD snooping. The default value is disabled.
Enabling Bridge Multicast Filtering on the Switch
1.
Open the
Multicast Global Parameters
page.
2.
Select
Enable
in the
Bridge Multicast Filtering
field.
3.
Click
Apply Changes
.
Bridge Multicast is enabled on the switch.
Enabling Multicast Forwarding and/or IGMP Snooping Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Multicast Commands
The following table summarizes the equivalent CLI commands for this feature.
Bridge Multicast Group
Use the Bridge Multicast Group page to create new multicast service groups or to modify ports and
LAGs assigned to existing multicast service groups. Attached interfaces display in the Port and LAG
tables, and reflect the manner in which each is joined to the Multicast group.
To display the Bridge Multicast Group page, click Switching
→
Multicast Support
→
Bridge Multicast
Group in the tree view.
Table 7-38. Multicast Commands
CLI Command Description
bridge multicast filtering Enables filtering of Multicast addresses.
ip igmp snooping Enable Internet Group Management Protocol (IGMP) snooping
globally or on an interface.
ipv6 mld snooping Enables MLD Snooping globally or on an interface.
show ip mcast Displays the system-wide multicast information.
show ip igmp snooping interface Displays IGMP snooping configuration.
To Next Page
Loading...
Need help?
General
