Dell PowerConnect 6224 User Manual

Configuring System Information 143
The server is removed, and the device is updated.
Working with Remote Server Logs Using CLI Commands
For information about the CLI commands that perform this function, see the Syslog Commands chapter
in the
CLI Reference Guide . The following table summarizes the equivalent CLI commands you use to
work with remote server logs.
Defining IP Addressing
Use the IP Addressing page to assign management interface and default gateway IP addresses, negotiate
with the Domain Name System, set a Default Domain Name, perform Host Name Mapping, and define
ARP and DHCP parameters for the interfaces.
To display the IP Addressing page, click System
→ IP Addressing in the tree view. Use this page to go to
the following features:
• Domain Name Server (DNS)
• Default Domain Name
•Host Name Mapping
• Dynamic Host Name Mapping
•ARP Table
• IPv6 Management Features
Table 6-14. Remote Server Logs Commands
CLI Command Description
logging facility Use to set the facility for logging messages.
logging
<host> Logs messages to the specified syslog server.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)