410 Configuring Switching Information
Configuring MLD Snooping with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• IPv6 MLD Snooping Commands
The following table summarizes the equivalent CLI commands for this feature.
MLD Snooping Global Querier Configuration
Use the
MLD Snooping
Global Querier Configuration page to configure the parameters for the MLD
Snooping Querier.
To display the Global Querier Configuration page, click Switching
→
Multicast Support
→
MLD
Snooping
→
Global Querier Configuration in the tree view.
Table 7-46. MLD Snooping Commands
CLI Command Description
ipv6 mld snooping immediate-leave Enables or disables MLD Snooping immediate-leave admin mode on a
selected interface or VLAN.
ipv6 mld snooping groupmembership-
interval
Sets the MLD Group Membership Interval time on a VLAN or
interface.
ipv6 mld snooping maxresponse Sets the MLD Maximum Response time for an interface or VLAN.
ipv6 mld snooping mcrtexpiretime Sets the Multicast Router Present Expiration time.
ipv6 mld snooping (Global) Enables MLD Snooping on the system (Global Config Mode).
ipv6 mld snooping (Interface) Enables MLD Snooping on an interface.
ipv6 mld snooping (VLAN) Enables MLD Snooping on a particular VLAN and all interfaces
participating in that VLAN.
show ipv6 mld snooping Displays MLD Snooping information.
show ipv6 mld snooping groups Displays the MLD Snooping entries in the MFDB table.
To Next Page
Loading...
Need help?
General
