Dell PowerConnect 6224 User Manual

646 Configuring IPv6
OSPFv3 Stub Area Summary
Use the OSPFv3 Stub Area Summary page to display OSPFv3 stub area detail.
To display the page, click IPv6
→ OSPFv3 → Stub Area Summary in the tree view.
Figure 10-20. OSPFv3 Stub Area Summary
The OSPFv3 Stub Area Summary page displays the following fields:
• Area ID — The Area ID of the Stub area.
•
Metric Value — The metric value applied to the default route advertised into the area.
•
Import Summary LSAs — Whether the import of Summary LSAs is enabled or disabled.
Displaying the OSPFv3 Stub Area Summary Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• OSPFv3 Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 10-15. OSPFv3 Stub Area Summary Command
CLI Command Description
show ipv6 ospf stub table Displays the OSPF stub table.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)