Dell PowerConnect 6224 User Manual

682 Configuring Quality of Service
Changing Diffserv Admin Mode
1. Open the Diffserv Configuration page.
2. Tu r n Diffserv Admin Mode on or off by selecting Enable or Disable from the drop-down menu.
3. Click Apply Changes .
The Diffserv Admin Mode is changed, and the device is updated.
Displaying MIB Tables Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands
The following table summarizes the equivalent CLI commands for this feature.
Class Configuration
Use the Diffserv Class Configuration page to add a new Diffserv class name, or to rename or delete an
existing class.
To display the
page, click Quality of Service → Differentiated Services → Class Configuration in the tree
view.
Table 11-1. DiffServ Configuration Commands
CLI Command Description
diffserv Sets the DiffServ operational mode to active.
show diffserv Displays the DiffServ General Status information.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)