Dell PowerConnect 6224 User Manual

208 Configuring System Information
• CP Configuration — Lists the captive portals configured on the switch by number and name.
•
Interface List — Lists the interfaces available on the switch that are not currently associated with a
captive portal.
Use the following steps to associate one or more interfaces with a captive portal:
1.
Select the desired captive portal from the CP Configuration list.
2. Select the interface or interfaces from the Interface list. To select more than one interface, hold CTRL
and click multiple interfaces.
3. Click Apply Changes .
NOTE: When you associate an interface with a captive portal, the interface is removed from the Interface List.
Each interface can be associated with only one captive portal at a time.
Use the following steps to remove an interface from the Associated Interfaces list for a captive portal:
1.
Select the desired captive portal from the CP Configuration list.
2. In the Associated Interfaces field, select the interface or interfaces to remove. To select more than one
interface, hold
CTRL and click multiple interfaces.
3. Click Delete .
4. The interface is removed from the Associated Interface list and appears in the Interface List.
CP Status
The CP Status page contains a variety of information about the CP feature. From the CP Status page,
you can access information about the CP activity and interfaces.
To view captive portal status information, click System
→ Captive Portal → Status.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)