Dell PowerConnect 6224 User Manual

Configuring Switching Information 431
– Available — Specifies available power sourcing equipment's power value in tenths of watts on the
port of local device.
–
Source — Specifies power source of this port.
–
Priority — Specifies PSE port power priority.
•
Extended PoE PD — If an extended PD TLV is present in LLDP frame, the following information
displays:
–
Required — Specifies required power device power value in tenths of watts on the port of local
device.
–
Source — Specifies power source of this port.
–
Priority — Specifies PD port power priority.
Viewing LLDP-MED Local Device Information with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• LLDP Commands
The following table summarizes the equivalent CLI commands for this feature.
LLDP-MED Remote Device Information
Use the LLDP-MED Remote Device Information page to view the advertised LLDP data advertised by
remote devices.
To display the LLDP-MED Remote Device Information page, click Switching
→ LLDP → LLDP-MED →
LLDP-MED Remote Device Information in the tree view.
Table 7-55. LLDP-MED Local Device Information Command
CLI Command Description
show lldp med local-device Displays the advertised LLDP local data.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)