Dell PowerConnect 6224 User Manual

268 Configuring System Information
Figure 6-120. OSPFv3 Trap Flags
The OSPFv3 Trap Flags page contains the following fields:
•Error Traps
– Bad Packet — Signifies that an OSPF packet has been received on a non-virtual interface that
cannot be parsed. The factory default is disabled.
–
Configuration Error — Signifies that a packet has been received on a non-virtual interface from a
router with configuration parameters that conflict with this router's configuration parameters. The
factory default is disabled.
–
Virtual Bad packet — Signifies that an OSPF packet has been received on a virtual interface that
cannot be parsed. The factory default is disabled.
–
Virtual Link Configuration Error — Signifies that a packet has been received on a virtual
interface from a router with configuration parameters that conflict with this router's configuration
parameters. The factory default is disabled.
•LSA Traps

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)