400 Configuring Switching Information
5.
Click
Apply Changes
.
The IGMP Snooping settings are modified, and the device is updated.
Copying IGMP Snooping Settings to Multiple Ports, LAGs, or VLANs
1.
Open the
General
IGMP
snooping
page.
2.
Click
Show All
.
The
IGMP
Snooping Table
displays.
3.
Click
Copy Parameters From
.
4.
Select a Unit/Port, LAG, or VLAN to use as the source of the desired parameters.
5.
Click
Copy To
for the Unit/Ports, LAGs, or VLANs that these parameters will be copied to.
6.
Click
Apply Changes
.
The IGMP Snooping settings are modified, and the device is updated.
Configuring General IGMP Snooping Settings with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• IGMP Snooping Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-42. IGMP Snooping Commands
CLI Command Description
ip igmp snooping (Interface) Enables Internet Group Management Protocol (IGMP) snooping on a
specific VLAN.
ip igmp snooping host-time-out Configures the host-time-out.
ip igmp snooping leave-time-out Configures the leave-time-out.
ip igmp snooping mrouter-time-out Configures the mrouter-time-out.
show ip igmp snooping groups Displays Multicast groups learned by IGMP snooping.
show ip igmp snooping interface Displays IGMP snooping configuration.
ip igmp snooping (VLAN) In VLAN Config mode, enables IGMP snooping on a particular VLAN
or on all interfaces participating in a VLAN.
ip igmp snooping fast-leave Enables or disables IGMP Snooping fast-leave mode on a selected
VLAN.
ip igmp snooping groupmembership-
interval
Sets the IGMP Group Membership Interval time on a VLAN.
To Next Page
Loading...
Need help?
General
