Dell PowerConnect 6224 User Manual

96 Configuring Dell PowerConnect
5. Select the image for the next boot by entering the boot system command. After this command,
enter the command
show version to verify that the copy indicated as a parameter in the boot
system
command is selected for the next boot.
The following is an example of the information that appears:
console#boot system image2
Activating image image2 ..
console>show version
Image Descriptions
image1 : default image
image2 :
Images currently available on Flash
--------------------------------------------------------------
unit image1 image2 current-active next-active
--------------------------------------------------------------
1 3.2.1.0 3.2.1.1 image1 image2
If the image for the next boot is not selected by entering the boot system command, the system
boots from the currently active image (image1, as given in the example).
6. Enter the command reload . The following message displays:
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n)
7.
Enter y . The following message then displays.
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n)
8.
Enter y to reboot the switch.

Dell PowerConnect 6224 Specifications

General

Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
Power Supply	100-240 VAC, 50/60 Hz
RAM	128 MB
Flash Memory	32 MB
Layer Support	Layer 2/3
Stacking	Up to 12 units
Weight	12.1 lbs
MAC Address Table Size	16, 000
Jumbo Frame Support	Up to 9, 216 bytes
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000BASE-T
VLAN Support	Yes (802.1Q)
Dimensions	17.3 x 13.8 x 1.7 in (440 x 350 x 44 mm)