Xerox PHASER 7500 Service Manual

3-26 Phaser 7500 Printer Service Manual
Error Messages and Codes
NET/ USB System Fail
Procedure
1. Check if the Controller ROM is the latest version. If it is not the latest, upgrade
the software.
2. Check the connection between the Image Processor Board and the Net to
install them securely, then turn the power On.
Check for faulty ports or Net connection. Check which of the following ports is
faulty.
•SNMP
•NetWare
• Salutation IO
•SMB
• Port 9100
•USB
•lpd
•FTP Serv
•MailO
•IPP
After checking, perform the same operation where the error occurred. If the
problem persists, obtain the "info9 or xxx.tgz" log using the log tool.
3. If the problem persists, reinstall or replace the RAM DIMM and then turn the
power On. Perform the same operation where the error occurred.
4. If the problem persists, replace the Image Processor Board (REP 35.1,
page 8-220) since it may be faulty. Perform the same operation where the
error occurred.
5. If the system is not restored after the Image Processor Board has been
replaced, reinstall the original Image Processor Board.
6. Return the NVM that was set to "1".

Xerox PHASER 7500 Specifications

General

Brand	Xerox
Model	PHASER 7500
Category	Printer
Language	English