3-86 Phaser 7500 Printer Service Manual
Error Messages and Codes
Paper Type Mismatch
Paper type designated on the UI does not match the paper type detected by the
Transparency Sensor.
Applicable Chain-Link Code
• 024-934: Paper Type Mismatch
Initial Actions
• Inspect the tray to ensure that it is free of obstructions, is loaded with
supported paper, and the Guides are adjusted correctly.
• If the problem persists, follow the procedure below.
1. Load the specified transparencies.
2. Perform the OHP Sensor test in Diagnostics.
3. If the problem still persists, perform the following “Common System Fail” on
page 3-22.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
To Next Page
Loading...
Need help?
General