5C-19 Clutch:
Push Rod (Right)
Inspect the push rod for wear and damage.
If any defects are found, replace the push rod with a new
one.
Clutch Sleeve Hub and Primary Driven Gear
Assembly
Inspect the slot of the clutch sleeve hub and primary
driven gear assembly for damage or wear caused by the
clutch plates. If necessary, replace it with a new one.
Specifications
Service Data
B718H15307001
Clutch
Unit: mm (in)
Tightening Torque Specifications
B718H15307002
NOTE
The specified tightening torque is also described in the following.
“Clutch Hose Routing Diagram (Page 5C-2)”
“Clutch Control System Components (Page 5C-6)”
“Clutch Components (Page 5C-12)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page 0C-7)”.
I718H1530063-01
I718H1530064-01
Item Standard Limit
Clutch drive plate thickness No.1, 2, 3 3.72 – 3.88 (0.146 – 0.153) 3.42 (0.135)
Clutch drive plate claw width No.1, 2, 3 13.9 – 14.0 (0.547 – 0.551) 13.1 (0.52)
Clutch driven plate distortion — 0.10 (0.004)
Clutch spring free length 65.0 (2.56) 61.8 (2.43)
Clutch master cylinder bore 14.000 – 14.043 (0.5511 – 0.5529) —
Clutch master cylinder piston diam 13.957 – 13.984 (0.5495 – 0.5506) —
Clutch release cylinder bore 38.18 – 38.23 (1.503 – 1.505) —
Clutch release cylinder piston diam 38.08 – 38.13 (1.500 – 1.501) —
Clutch fluid type Brake fluid DOT 4 —
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Air bleeder valve (Clutch)
60.6 4.5
)(Page 5C-4) /
)(Page 5C-5)
Clutch master cylinder holder bolt 10 1.0 7.0 )(Page 5C-7)
Clutch hose union bolt 23 2.3 16.5 )(Page 5C-8)
Clutch lever pivot bolt 6.0 0.6 4.5 )(Page 5C-9)
Clutch lever pivot bolt lock-nut 6.0 0.6 4.5 )(Page 5C-9)
Clutch sleeve hub nut 150 15.0 108.5 )(Page 5C-15)
Clutch spring set bolt 10 1.0 7.0 )(Page 5C-17)
To Next Page
Loading...
Need help?
General
