Brother PR655 - Driving Jump Disassembly

2 - 51
Main unit
Upper shaft unit
Disassembly Disassembly
4 Driving jump disassembly
1. Remove the 2 screws 1, and then remove the J differential lever 1, thrust
washer, and J slide lever assembly 2.
2. Remove the retaining ring E4, and then remove the J slide lever shaft 3
from the J slide lever.
3. Remove the retaining ring E4, and then remove the J differential lever 1
from the J link assembly.
4. Remove the J driving lever 4 and the spring from the J base
assembly.
5. Remove the screw 2, and then remove the J cushion pin and the J cushion.
1
12
3
Retaining ring E4
Retaining ring E4
1
4
2
S46
S46