Maintenance & Troubleshoot
H00007091 - Absolute Arm User Manual │Version 5.2.0 (2019-03-07) │170
H.3 CLEANING
H.3.1 CLEANING THE ARM
Before cleaning, switch off the system, and disconnect the power supply cable.
• When unused, protect the arm from the dust with the provided dust cover.
• When unused, place back the accessories in the provided accessory case.
• When needed, clean the arm
• clean with a soft rag, lightly dampened with pure water or water diluted with a soft detergent.
• do not use other detergents, solvent or alcohol to avoid any risk of damage.
• use compressed air to remove loose particles.
• for removing tough pollutions, use wadded-cotton tips.
When cleaning the Wrist display on the 7-axis arm, do not press on the glass.
H.3.2 CLEANING THE SCANNER
Requirements
• Lens pen (e.g. “MicroPro” from Hama)
Or
• Microfiber cloth (Important: low linting; non-scratching
on optical components)
(e.g.: 3M - Scotch Brite, Professional High-
Performance Cloth, Part No.: 07926)
• Cotton bud (Q-Tip) (Important: low linting; non-
scratching on optical components
• Compressed air (Important: high purity, dry, oil-free)
For severe dust/dirt:
• Soft cleaning alcohol (e.g. Isopropanol)
Important: maximum 90% Isopropanol (+10% distilled, purified water), (e.g.: 3M VHB Surface
Cleaner)
To Next Page
Loading...
Need help?
General
