Issue 2.0
SV9100 Networking Manual 7-7
2.4 Configure Call Routing for H.323
Enter the remote destination information in Program 10-23. This allows up to 1000
SIP or H.323 destinations (remote systems) to be entered. If more than 1000
destinations are required, it is necessary to use an external H.323 Gatekeeper or
SIP Server.
It may be advantageous to configure F-route to route calls to remote destinations
via the IP trunks (this can simplify dialing for the users). F-route configuration is
discussed fully in the UNIVERGE SV9100 Features and Specifications Manual.
2.4.1 H.323 Call Routing
Use the following programs to assign H.323 call routing.
Table 7-6 H.323 Call Routing Assignments
Program/
Item No.
Description/
Selection
Assigned Data Comments
10-23-01
SIP System Interconnection
Setup – System Interconnect
0 = Disable (No)
1 = Enable (Yes)
Default is 0
Enable/Disable the remote
destination.
10-23-02
SIP System Interconnection
Setup – IP Address
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
Default = 0.0.0.0
Enter the IP address for the remote
system.
10-23-04
SIP System Interconnection
Setup – Dial Number
Up to 12 digits (0~9)
Default not assigned
Enter the alias number for the remote
system.
This is the E.164 number assigned
to the remote destinations.
10-23-05 Keep Alive Mode for SIP 0 = Disable
1 = Enable
(default = 0)
10-23-06 SIP Profile 1 = Profile 1
2 = Profile 2
(default = 1)
Only used when Trunk Type is
defined as (SIP) in PRG 10-68-01.
To Next Page
Loading...
Need help?
General
