Issue 2.0
SV9100 Networking Manual 13-39
Message Waiting
3.21 Message Waiting
This feature can be used when placing an intercom call to a networked extension and receives either no
answer or hears a busy tone.
With a networked system, when a Message Waiting has been left, there is a slight difference in the telephone’s
display. With a single system, the extension’s name which left the message is displayed. With a networked sys-
tem, the extension number is displayed.
Operation
To leave a Message Waiting:
1. Call busy or unanswered extension.
2. Dial the Message Waiting service code *0
OR
3. ress Message Waiting key (PGM 15-07 or SC 751: 38)
4. Hang up.
With system phones, the MW LED lights.
To answer a Message Waiting:
When you have a message, your MW LED flashes fast for system phones.
1. At a system phone, press SPK key and dial *0.
OR
Press Message Waiting key (PGM 15-07 or SC 751: 38).
OR
At single line telephones, lift the handset and dial *0.
If the called extension doesn’t answer, dial 0 or press your Message Waiting key to automatically leave
them a message.
Normally, your MW LED goes out. If it continues to flash, you have new messages in your “Voice Mail” mailbox
or a new “General Message”. Go to “To check your messages” below.
Related Programs
Program Number Title
11-11-09 Service Code Setup (for Setup/Entry Operation) - Answer Message
Waiting
11-11-10 Service Code Setup (for Setup/Entry Operation) - Cancel All Messages Wait-
ing
11-11-11 Service Code Setup (for Setup/Entry Operation) - Cancel Message
Waiting
11-16-07 Single Digit Service Code Setup: Message Waiting
20-13-07 Class of Service Options (Supplementary Service) - Message Waiting
To Next Page
Loading...
Need help?
General
