Issue 2.0
3-4 System Data Programming <US Only>
1.3 Numbering Plan Assignment
Use these programming assignments to indicate to the system the number of
digits that are assigned to stations, the number of digits assigned to Access
Codes, and to assign stations to ports.
1.4 Programming for Closed Numbering Plan
Use these programs to assign an Access Code to the Intercom Function
Numbers, to assign F-Routes to the appropriate Trunk Routes, and specify the
digits that are added to the dialed number.
Table 3-3 Numbering Plan Assignments
Program/
Item No.
Description/
Selection
Assigned Data Comments
11-01-01
System Numbering
0 = Not Used1 = Service
Code
2 = Extension Number
3 = Trunk Access
4 = Special Trunk Access
5 = Operator Access
6 = Flexible Routing
9 = Dial Extension Analyze
Default for 1X, 2X, and 3X is 2.
11-02-01
Extension Numbering
Assign Station Numbers to
Port Numbers
Defaults for Ports 1 ~ 960:
101 ~ 199
3101 ~ 3961
11-04-01
Virtual Extension
Numbering
Assign Station Numbers to
Port Number
Defaults for Ports
1 ~ 99 = 201~ 299
100 ~ 512 = Not Assigned
Table 3-4 Closed Numbering Plan Assignments
Program/
Item No.
Description/
Selection
Assigned Data Comments
11-01-01
System Numbering
2 = Extension Number Default for 1X, 2X, and 3X is 2.
44-02-01
Dial Analysis Table for
ARS/F-Route Access –
Dial
Number of digits to be
analyzed by the system.
Up to eight digits can be
assigned.
Default is No Setting.
Assign the digits to be dialed
across the K-CCIS link. These
digits were assigned as F-Route
in Program 11-01-01.
(Use line key l for “Don’t Care”
digit @.)
44-02-02
Dial Analysis Table for
ARS/F-Route Access –
Service Type
2 = ARS/F-Route Table
Default is 0
Service type 2 assigns the digits
to be dialed to an F-Route.
Program 44-02-03 assigns the
F-Route to be used.
To Next Page
Loading...
Need help?
General
