Issue 2.0
SV9100 Networking Manual 3-5
1.5 Programming for Open Numbering Plan
Use these programs to assign the number of digits to Access Code and to make
ARS assignments.
44-02-03
Dial Analysis Table for
ARS/F-Route Access –
Additional Data
2 = 0 ~ 500
(0 = No Setting)
Default is 0
When setting data is 2, refer to
Program 44-05 for further routing
options.
44-05-01
ARS/F-Route Table –
Trunk Group Number
0-100,101-150,255
0 = Not Set
1~100 = Trunk Group from
14-05
101~150 = Networking
255 = Extension Call
Default is 0
Select the trunk group to be used
for the outgoing K-CCIS call.
Table 3-5 Open Numbering Plan Assignments
Program/
Item No.
Description/
Selection
Assigned Data Comments
11-01-01
System Numbering
2 = Extension Number Default for 1X, 2X, and 3X is 2
44-02-01
Dial Analysis Table for
ARS/F-Route Access –
Number of digits to be
analyzed by the system
Up to eight digits can be
assigned.
Default is No setting
Assign the digits to be dialed
across the K-CCIS link. These
digits were assigned as F-Route
in Program 11-01-01.
Use line key l for “Don’t Care”
digit @.
44-02-02
Dial Analysis Table for
ARS/F-Route Access –
Service Type
2 = ARS/F-Route Table
Default is 0
Service type 2 assigns the digits
to be dialed to an F-Route.
Program 44-02-03 assigns the
F-Route to be used.
44-02-03
Dial Analysis Table for
ARS/F-Route Access –
Additional Data
2 = 0 ~ 500
(0 = No Setting)
Default is 0
When setting data is (2), refer to
Program 44-05.
44-05-01
ARS/F-Route Table –
Trunk Group Number
0-100,101-150,255
0 = Not Set
1~100 = Trunk Group from
14-05
101~150 = Networking
255 = Extension Call
Default is 0
Select the trunk group to be used
for the outgoing K-CCIS call.
Table 3-4 Closed Numbering Plan Assignments (Continued)
Program/
Item No.
Description/
Selection
Assigned Data Comments
To Next Page
Loading...
Need help?
General
