Issue 2.0
SV9100 Networking Manual 13-55
sion . The second row of the display “KY01 = *01” indicates that Key 01 is being programmed
with the entry of *01. The third row allows you to move the cursor to the left or right, depending on
which arrow is pressed. To learn how to enter the programming mode, refer to 4.3) How To Enter
Programming Mode below.
4.3 How to Enter Programming Mode
To enter programming mode:
1. Go to any working display telephone.
In a newly installed system, use extension 101 (port 1).
2. Do not lift the handset.
3. Press Speaker.
4.
# * # * .
5. Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the passwords, use 90-
02 : Programming Password Setup.
Password
Password
User
Name
Level Programs at this Level
------ ------ 1 (MF) Manufacturer (MF):
All programs
12345678 tech 2 (IN) Installation (IN):
All programs in this section not listed below for SA and
SB
0000
ADMIN1 3 (SA)
System Administrator – Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17,
10-18, 10-22, 12-02, 12-03, 12-04, 15-01, 15-07, 15-09,
15-10, 15-11, 20-16, 21-07, 21-14, 22-04, 22-11, 25-08,
30-03, 32-02, 40-02, 41-02, 41-03, 41-04, 41-05, 41-06,
41-07, 41-08, 41-09, 41-10, 41-11, 41-12, 41-13, 41-14,
41-15, 41-16, 41-17, 41-18, 90-03, 90-04, 90-06, 90-07,
90-18, 90-19
9999
ADMIN2 4 (SB)
System Administrator – Level 2 (SB):
13-04, 13-05, 13-06
To Next Page
Loading...
Need help?
General
