To Next Page

To Previous Page

Issue 2.0

10-48 SV9100 NetLink

Configuration Flow (Case 1) – Primary Based on System ID

1. Create a Recovery Database – Recommended.

Because each communication server database and communication server

configuration are updated by the Primary System, creating a recovery database is

recommended. This may be needed if the communication server goes back to a

stand-alone server.

Refer to the Section 8 Communication Server Database Synchronization on page

10-37 and Section 9 Create Recovery Database on page 10-39 sections.

2. For NetLink, the minimum programs must be set:

 System IP Address List (Program 51-03-01)

 System ID (Program 51-01-01)

3. After entering the System ID, the communication server asks to reboot the

communication server. Reboot.

4. When the communication server comes up, the Primary System and Secondary

Systems are determined automatically.

If you need to change the Primary System to another server, use 7.1 Forced

Change Primary System on page 10-36

When connection cannot be made to the original Primary System, and a new

Primary is selected, it can automatically return the original server as the Primary

System after connection/power is restored. Refer to the Section 7 Top Priority

Primary System (Primary System Automatic Integration) on page 10-35 function.

CAUTION

Before programming the NetLink feature, general IP configuration

must be performed.

❍ Program 10-12-09 : VoIPDB IP Address