Issue 2.0
SV9100 Networking Manual 10-9
The SV9100 Encryption feature is only supported in the primary system.
3.2.3 IP Trunks
When configuring SIP Trunks on Netlink Secondary system, only SIP Profile
One is supported.
3.2.4 General limitations
SV8100 CPU is not supported in a Netlink environment with SV9100
CPU.
The Primary System (Main Site) requires the appropriate NetLink
licenses dependant upon the number of nodes in the NetLink
network.
Up to 50 Nodes can be supported in a NetLink network.
When the attendant's telephone exists on a secondary system, alarm
information cannot be displayed on the attendant's telephone.
When Fail Over occurs between the Primary System and two or more
Secondary Systems, the attendant telephone displays the System ID
of the system that went into Fail-Over last.
A maximum of 240 Virtual slots are supported.
Port assignment is performed sequentially by the requested order
from the Secondary Systems.
All nodes in a NetLink network should have the same main
GCD-CP10 software.
When a Terminal is placed on hold, the Music on Hold comes from
the system where the Terminal resides.
When a trunk is placed on hold, the Music on Hold comes from the
system where the trunk resides.
External Paging uses an output on the GCD-CP10 of the Primary
System.
A PGD(2)-U10 ADP must be used if External Paging is required in
the Secondary Systems.
License information in the Primary will be copied to the Secondary
site when doing database duplication.
Duplicate license information in the Secondary System is available for
only seven days.
Duplicate license information in the Secondary System is available for
only 28 days.
To Next Page
Loading...
Need help?
General
