EasyManuals Logo

NEC Univerge SV9100 User Manual

NEC Univerge SV9100
766 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #597 background imageLoading...
Page #597 background image
Issue 2.0
13-2 AspireNet
Paging
AspireNet allows a user to place Paging call to a networked system. If you need to get through to a co-
worker who is not at their desk then place a paging call to their system.
Call Forwarding
You can forward your calls to an extension at another networked extension. If you visit another site
within your network but forgot to set a call forward then use Follow Me to have your calls forwarded to
you. Follow Me is also useful if you have an DECT handset. If your handset is subscribed at the site
you are visiting then you can use Follow Me to have your calls forwarded to your DECT handset.
Direct Dial In(DDI)
A DDI call can be routed to any extension within the network. This allows an extension to receive a
DDI call from any other system in the network. Along with trunk access it is possible for an extension
on a system that has no trunk lines to use the trunks of another system in the network.
Trunk Access
An extension can access a trunk line at another system in the network. The user dials the standard
trunk access code and the system will automatically route the call to the system that has trunks
connected.
Conference
An extension can have a conference call that includes co-workers at another system within the
network.
1.2 SV9100 PCBs
There are two methods available for AspireNet connection as shown in the following table.
ISDN AspireNet
Using ISDN AspireNet the system provides up to 256 B-channel ports which can be used for
Networking.
A PRIA circuit will take 30 ports and each BRI circuit will take 2 ports.
These ISDN AspireNet ports are independent of the trunk and station ports available on the system.
IP AspireNet
Using IP AspireNet the maximum quantity of simultaneous calls is limited by the availability of
resources on the IPLE PCB’s installed. A PZ-IPLE PCB’s giving a maximum of 256 speech channels.
The maximum quantity of calls may also be reduced by the compression mode (CODEC type) of the
IPLE PCB’s, this is selectable by the installer in Program 84-12-28.
Interface Description Note
ISDN Using Q.931 based proprietary protocol,
Basic rate interface and Primary rate
interfaces are available.
A PRIA or BRIA Blade is
required for connection.
VoIP Using H.323 protocol for voice transmit
protocol.
An IPLE daughter board is
required.

Table of Contents

Other manuals for NEC Univerge SV9100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Univerge SV9100 and is the answer not in the manual?

NEC Univerge SV9100 Specifications

General IconGeneral
VoIP SupportYes
VoIP ProtocolsSIP, H.323
VoicemailIntegrated voicemail
NetworkingYes, via IP
Unified CommunicationsYes
MobilitySupports mobile extensions and applications
TypeIP-PBX
Network InterfacesGigabit Ethernet
Power SupplyAC 100-240V, 50/60Hz
Operating Temperature32°F to 104°F (0°C to 40°C)
Storage Temperature-20°C to 60°C (-4°F to 140°F)
WeightVaries depending on chassis and expansion cards

Related product manuals