NEC Univerge SV9100 User Manual

Issue 2.0
SV9100 Networking Manual 10-17
 For InMail remote CCIS extensions are not supported in a centralized directory.
3.9 FoIP
 FoIP (Fax over IP) is supported in a NetLink network.
SECTION 4 LIST OF SUPPORTED FEATURES IN SECONDARY SYSTEM
The following table lists supported features.
Table 10-3 Supported Features in Secondary System
Feature Name
Supported in
Secondary
System
Comments
Account Code – Forced/Verified/
Unverified
Yes
Account Code Entry
Yes
Alarm
Yes
Alarm Reports
Conditions
Programs 90-10-80 ~ 90-10-95 are not supported.
Alphanumeric Display
Yes
Analog Communications Interface
(ACI)
Yes
Ancillary Device Connection
Yes
Answer Hold
Yes
Answer Key
Yes
Attendant Call Queuing
Yes
Automatic Call Distribution (ACD)
Conditions
Fail-Over: VRS card must be installed in Primary
system.
MIS monitor must be connected to the Primary system.
If you are logged in and Fail-over occurs the agent will
not be logged back in when the Secondary system
takes over. The agent will have to manually log back in
to continue taking calls.
Automatic Release
Yes
Automatic Route Selection
Conditions
Fail-Over: ARS Class Of Service must be
programmed for each System in a NetLink Network to
ensure proper call routing during Fail-Over.

NEC Univerge SV9100 Specifications

General

VoIP Support	Yes
VoIP Protocols	SIP, H.323
Voicemail	Integrated voicemail
Networking	Yes, via IP
Unified Communications	Yes
Mobility	Supports mobile extensions and applications
Type	IP-PBX
Network Interfaces	Gigabit Ethernet
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Weight	Varies depending on chassis and expansion cards