Issue 2.0
SV9100 Networking Manual 10-13
In-Mail and VRS use the VMDB of the Primary (Main) site.
APSU can be installed in the Secondary (Remote) System, however
the NetLink time zone follows the Primary (Main) System.
When installing a Secondary System in a Netlink network and the
Secondary System has GCD-LCA blades installed, the GCD-LCA
blades will come online and assign ports before any GCD-DLCA
blades are assigned.
Secondary systems must follow the primary CPU software settings
for Mu-law/A-law within the country where the primary system is
located. SV9100 NetLink connections are only supported within the
same countries/areas. For example, the SV9100 can be connected
via NetLink between the US and Canada, however the SV9100
cannot be connected via NetLink with systems in other countries
(e.g., Mexico or the U.K.).
Synchronous Ringing via NetLink is not supported.
Always connect to the Primary System when using PCPro.
When using K-CCIS - T1 in a Netlink system, the CCTA blade is only
supported in the primary system.
The following programs require a reset after making a change using
PCPro, WebPro or Handset programming:
3.3 DSP
(PB Receiver, Dial Tone Detector, Caller ID Detector, Caller ID Sender, MF
Receiver).
Table 10-2 CPU Reset Programs
Program When Changed Using
10-12-01 Handset, WebPro, PCPro
10-12-02 Handset, WebPro, PCPro
10-12-09 Handset, WebPro, PCPro
51-01-01 Handset, WebPro, PCPro
51-15 WebPro, Handset Programming
84-03-06 Handset, WebPro, PCPro
90-04 Handset Programming
90-58 Handset Programming
10-46-07 PcPro
84-23 Handset, WebPro, PCPro
To Next Page
Loading...
Need help?
General
