Chapter 17 Files
1012
Overview of File Operations
File copying between different unit IDs
Switcher and DME files within the hard disk or memory card are managed by
unit ID.
To copy files between different unit IDs, use the Unit ID Copy menu.
For details of operations, see “Copying Files Between Different Unit IDs”
(page 1035).
Saving data recalled by autoload
At power on, you can automatically recall data previously stored on the hard
disk. (Autoload function)
The following data can be loaded by the autoload function.
• Keyframe effect setting data
• Snapshot setting data
• Wipe snapshot setting data
• DME wipe snapshot setting data
• Key snapshot setting data
• Shotbox setting data
• Macro setting data
• Macro attachment data
• Frame memory image data
To use the autoload function, the data required must first be saved.
For the on/off setting of the autoload function, see “Selecting the State After
Powering On (Start Up Menu)” in Chapter 18 (Volume 3).
For details of saving operations, see “Saving Files Recalled by Autoload”
(page 1037).
Locking file recall operations
For each of the following categories, in setup you can apply a lock on recalling
files.
Setup, Initial Status, Key Memory, Video Proc Memory, Effect, Snapshot,
Wipe Snapshot, DME Snapshot, Key Snapshot, Shotbox, Macro, Macro
Attachment, Menu Macro
A locked file cannot be downloaded from the File menu.
For details of the settings, see “Locking the Setup Menu Settings” in Chapter
18 (Volume 3).
To Next Page
Loading...
Need help?
General