Chapter 20 Switcher Setup (Switcher)
1227
Settings Relating to Video Switching (Transition Menu)
Settings Relating to Video Switching
(Transition Menu)
For settings relating to video switching, use the Switcher >Transition menu.
To display the Transition menu
In the Engineering Setup menu, select VF3 ‘Switcher’ and HF4 ‘Transition.’
The status area shows the transition preview, key transition, bus toggle, and
split fader settings for each M/E and PGM/PST bank.
The following functions are available here.
• Transition Preview: Specify the operation mode for transition preview for
each of the M/E and PGM/PST banks.
• Key Transition: Specify the operation mode for independent key
transitions.
• Bus Toggle: Switch the bus toggle for each of the M/E and PGM/PST banks
on or off.
• Split Fader: When the bus toggle is off, the split fader settings are enabled.
For each of the M/E and PGM/PST banks, select enable or disable.
• Fade To Black: Enable or disable fade-to-black for each final program
output.
• Preset Color Mix: Set the stroke mode for a preset color mix, the key status
for a transition including a key, and the mode in which the transition type
after a transition ends returns to the previous setting.
• Transition Curve: Set the relationship when carrying out a transition,
between the fader lever position and the advancement state of the transition.
Selecting the Bank to Make the Settings
In the Transition menu, using any of the following methods, select the bank to
which the settings apply, then make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
The selected bank appears in reverse video.
Knob Parameter Adjustment Setting values
1 Bank M/E or P/P selection to which settings apply 1 to 4
To Next Page
Loading...
Need help?
General