Chapter 19 Control Panel Setup (Panel)
1195
Operation Settings (Operation Menu)
3
In the <SHTL/VAR Dial Range> group, select [Narrow] or [Wide] to set
the sensitivity for the search dial in shuttle mode or variable mode.
Narrow: The search speed varies in a relatively narrow range.
Wide: The search speed varies in a relatively wide range.
For details of search dial operations, see “Controlling the Tape/Disk
Transport” in Chapter 12 (Volume 2).
Specifying Main Split Fader
In the <Main Split Fader> group of the Panel >Operation menu, select [Left]
or [Right].
Setting the Macro Execution Mode
1
Press [Macro] in the Panel >Operation menu.
The Macro menu appears.
2
In the <Macro Execution Mode> group, select the macro execution mode.
Normal: normal execution mode
Step: step execution mode
3
In the <Flexi Pad Edit Mode> group, set the macro editing mode of the
standard type Flexi Pad to [Pause Only] or [Full Editing].
This enables the standard type Flexi Pad control block to be used for macro
editing. Depending on the macro editing mode setting, functions are
assigned to the memory recall buttons as shown in the following figure.
When the setting is
[Pause Only]
When the setting is
[Full Editing]
To Next Page
Loading...
Need help?
General