Chapter 18 System Setup (System)
1078
Setting the Signal Format (Format Menu)
Setting the Signal Format (Format Menu)
To set the format, that is, the frame frequency and number of scan lines handled
by each device, use the System >Format menu.
To display the Format menu
In the Engineering Setup menu, select VF1 ‘System’ and HF3 ‘Format.’
Notes
After changing any of the following settings, be sure to press [Execute] (or [FC
Format Execute] for changing the format converter signal format) to save the
new values. If you want to cancel the settings and return to the original state,
press [Clear] without pressing [Execute] or [FC Format Execute]. When you
press [Execute], some data is lost (such as frame memory images). If you press
[FC Format Execute], memory is not initialized, and this data is not lost.
When using 720P format (on a 4M/E system)
On a 4M/E system, it is not possible to use an M/E reentry signal in an overlaid
manner on the key bus or utility 1 bus even when not using the color corrector.
Example 1: When M/E-1 is selected on the M/E-2 background A bus (or
background B bus, key bus, utility 1 bus, or utility 2 bus), it is not possible
to select M/E-2 on the M/E-3 key bus or utility 1 bus.
Example 2: When M/E-2 is selected on the M/E-3 background A bus (or
background B bus, key bus, utility 1 bus, or utility 2 bus), it is not possible
to select M/E-3 on the PGM/PST key bus or utility 1 bus.
Setting the Signal Format
Specify the signal format to be handled by the devices.
The combinations of signal formats that can be selected are as follows.
To Next Page
Loading...
Need help?
General