Chapter 13 Keyframe Effects
825
Specifying the Region and Edit Points
Specifying the Region and Edit Points
Selecting the Region in Which Editing Applies
Selecting by control panel
Select the region in which the editing is applied by the effect consisting of
keyframes, using the region selection buttons in the numeric keypad control
block or Multifunction Flexi Pad control block. (See “Recalling a register from
the numeric keypad control block” (page 816).)
Selecting by menus
This is convenient for selecting some of the regions assigned to the numeric
keypad control block or changing the reference region.
Notes
The function of region selection buttons in the numeric keypad control block
or Multifunction Flexi Pad control block is linked to the menu. If you carry out
region selection by pressing a region selection button, then all the regions
assigned to that button are selected.
1
In the Key Frame menu, press HF7 ‘Region Select.’
The Key Frame >Region Select menu appears.
On the left of the status area, region selection buttons appear.
Depending on the region selection state, the following indications appear.
Green text: the assigned regions include the reference region.
Orange text: one of the assigned regions is selected.
White text: no assigned region is selected.
When any one or more of the regions assigned to the region selection
buttons is not selected, a red bar appears within the button indication. The
[STORE] and [RCALL] buttons in the numeric keypad control block flash
amber.
To Next Page
Loading...
Need help?
General