Chapter 19 Control Panel Setup (Panel)
1136
Overall Control Panel Settings (Config Menu)
4
Press [Set], to confirm the selection.
This assigns the selected key to the key delegation button.
To return the key delegation button assignment to the factory
default state
In the DSK/FTB Module menu, press [Default].
This returns the key delegation assignment to the factory default state.
Assigning Keys to the Independent Key Transition
Control Block (Simple Type)
It is possible to select the keys that can be used in an independent key transition
control block (simple type) operation.
For details of the independent key transition control block (simple type), see
Chapter 2 (Volume 1).
The control panel comprises a main base for installing the principal switcher
bank control blocks, and an extension section for extended control blocks. The
independent key transition control block (simple type) can be installed in
either, but the assignable keys differ as follows.
When the independent key transition control block (simple type) is
installed in the main base
Select the keys to be assigned from the following.
• Key1,2 (keys 1 and 2)
• Key3,4 (keys 3 and 4)
• DSK1,2 (downstream keys 1 and 2)
• DSK3,4 (downstream keys 3 and 4)
• N/A (no assignment)
In this case, “Key1,2” and “Key3,4” are the keys of the switcher bank (M/E-1,
M/E-2, M/E-3, PGM/PST) in which the independent key transition control
block is installed and whose assignment is determined by the M/E Assign
menu.
When the independent key transition control block (simple type) is
installed in the extension section
Select the keys to be assigned from the following.
• M/E-1 Key1,2
• M/E-1 Key3,4
• M/E-2 Key1,2
• M/E-2 Key3,4
To Next Page
Loading...
Need help?
General