Chapter 20 Switcher Setup (Switcher)
1203
Settings for Switcher Configuration (Config Menu)
• DME Config: Set the DME channel assignments used on the individual
M/E and PGM/PST banks.
• Side Flags: Make settings relating to the side flag function (inserting a
selected image on both sides of a 4:3 image).
Adjusting the Reference Phase
To adjust the switcher internal reference phase, in the Switcher >Config menu,
set the following parameter.
Specifying the Video Switching Timing
1
In the Switcher >Config menu, press [Switching Timing].
The Switching Timing menu appears.
2
Select any of the following.
Any: Not specified
Field 1: Field 1 (odd fields)
Field 2: Field 2 (even fields)
Notes
When the signal format is set to 720P or 1080PsF, this selection is not possible.
Setting the Operation Mode
In the <M/E Config> group of the Switcher >Config menu, select the operation
mode for each M/E or PGM/PST bank from the following.
• Standard mode
• Multi Program mode
• DSK mode (PGM/PST only)
For details of the modes, see the explanation of the M/E Config function (page
1202).
Knob Parameter Adjustment Setting values
3 Phase Switcher internal reference phase –32.00 to +96.00
To Next Page
Loading...
Need help?
General