Chapter 15 Utility/Shotbox
924
Shotbox Execution
1
In the numeric keypad control block, press the [SHOTBOX] button,
turning it on.
• This allocates the numeric keypad control block to shotbox operations.
• The [RCALL] button lights amber.
• The display shows the last recalled register number.
2
With the numeric keypad buttons, enter the desired register number.
• The display now shows the entered register number.
• If the specified register is empty, an “E” automatically appears after the
register number.
3
Press the [ENTER] button.
• This runs the specified shotbox register.
• The number of the recalled register appears in the display.
• The region selection buttons corresponding to the regions for which the
effect is set light.
• If auto run is set for the specified shotbox register, on recall the effect is
immediately executed.
• If you recall an empty register, then shotbox execution has no effect.
When auto run is not set for the recalled register
Simply recalling the register does not run the effect. To do this, in the
keyframe control block, press the [RUN] button.
Shotbox Execution in the Multifunction Flexi Pad
Control Block or the Flexi Pad Control Block
Notes
In the simple type of Flexi Pad control block, shotbox operations are not
possible. You can carry out shotbox operations with a standard type or
multifunction type Flexi Pad control block.
1
In the Flexi Pad control block, press the [SHOTBOX] button, lighting the
[SHOTBOX] button amber.
• This allocates the Flexi Pad control block to shotbox operations.
• The previously selected bank number and the last recalled register
number appear in the numeric display.
2
Using any of the following methods, select the bank.
• To select a register in bank 0, press the [BANK 0] button.
To Next Page
Loading...
Need help?
General