Chapter 10 Special Functions
489
Multi Program 2
Multi Program 2
Overview
What is Multi Program 2?
By operating the switcher in Multi Program 2 mode, a single switcher mix/
effects bank can be used to create two separate video outputs, referred to as
“main” and “sub.” You can set backgrounds, keys, and transitions for each of
main and sub. Keys 2 to 4, however, are common to main and sub.
Notes
The Multi Program 2 function is only supported on the MVS-8000A/8000G.
To enable this function requires the BZS-8200 Multi Program 2 software.
Depending on the CPU module, this function may not be supported.
For details, consult your Sony service representative or sales representative.
Using the software
To use the Multi Program 2 software, you are required to enter an install key
which validates the software. (If the software has been factory installed, the
install key is not required.)
For the method of obtaining an install key, contact your Sony representative.
To obtain a key, you may be required to submit the unique device ID of the
switcher you are using. You can check the unique device ID in the Install menu
of the switcher.
For details of the operation, see “Installation and Device Setup (Install/Unit
Config Menu)” in Chapter 18 (Volume 3).
Assigning main and/or sub to switcher banks
For Multi Program 2 operations, a single switcher bank may be shared, and
switched between main and sub, or two separate switcher banks may be used,
each dedicated to main or sub.
To Next Page
Loading...
Need help?
General