Chapter 18 System Setup (System)
1096
Installation and Device Setup (Install/Unit Config Menu)
4
Press [License Management].
The License Management menu appears.
5
Press [Deactivate License].
A confirmation message appears.
6
Press [Yes].
A license registration canceled message appears.
7
Press [OK].
The status area Condition box showing “Active” changes to blank.
8
Using either of the following methods, restart the device.
• In the System >Initialize menu, select only the device for which you
registered the license, and press [Reset] in the <Initialize> group.
• Power off and on again.
After restarting, the software for which the license registration has been
canceled is no longer available.
Adding User Texture Patterns
You can add user created texture patterns to the repertory of texture patterns
with which the spotlighting function enables the light falls on the image
surface.
Notes
This function is not supported on the MVE-8000/8000A.
For details of spotlighting and texture patterns, see “Spotlighting Settings” in
Chapter 11 (Volume 2).
The procedure for adding a texture pattern is as follows.
Prepare the texture file (next item)
m
Create the texture package (page 1100)
m
Install the texture package (page 1102)
To Next Page
Loading...
Need help?
General