Chapter 18 System Setup (System)
1100
Installation and Device Setup (Install/Unit Config Menu)
c Directory selection button
By pressing this button to display the popup window, you can select a directory
on the memory card.
d Texture file list
This shows the texture files stored on the memory card.
If a texture file is stored in a directory, press the directory selection button and
select the directory in the popup window, to show a list of files.
The list Capacity shows the file size in units of 128×128 pixels.
e Grid display of memory capacity
This shows how the texture files are stored in memory (an 8×8 grid, of 64
squares, each equivalent to 128×128 pixels).
And this shows the location where the texture files are stored in memory by
bold frames. The grid for the texture file selected in the texture number list is
shown in amber.
f Select button
Pressing this button assigns the texture file selected in the texture file list to the
number selected in the texture number list.
g Delete button
Pressing this button deletes the texture file assigned to the number in the
texture number list.
h Make Package button
Pressing this button creates the texture package.
Creating a texture package
To use a user-provided texture pattern with the spotlighting function, it is
necessary to convert the texture files to vector files for bump mapping. This
operation is referred to as “creating a texture package.”
1
Insert the memory card holding the texture file into the memory card slot.
2
In the Engineering Setup menu, select VF1 ‘System’ and HF6 ‘Install/Unit
Config.’
The Install/Unit Config menu appears; the status area shows the version
information for the software installed on the various devices.
3
Using any of the following methods, select a DME for which the
spotlighting license is valid.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
To Next Page
Loading...
Need help?
General