Chapter 19 Control Panel Setup (Panel)
1140
Overall Control Panel Settings (Config Menu)
2
Press [Joystick/Trackball Module].
The Joystick/Trackball Module menu appears.
The left of the status area shows the region selection buttons of the device
control block. The list on the right shows the devices and functions that can
be assigned.
3
In the button displays on the left, press the button for the assignment.
4
Using any of the following methods, select the device or function to be
assigned.
• Press directly on the list on the right.
• In the list on the right, press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
5
Press [Set].
This assigns the device or function selected in the list to the button.
To cancel an assignment
Select the button, then press [Clear].
This removes the assignment to that button.
To return all device selection button assignments to the factory
default state
In the Joystick/Trackball Module menu, press [Default].
Inhibiting Utility 2 Bus and Key Operations
You can inhibit operations on the utility 2 bus and keys 1 to 4 of the M/E and
PGM/PST banks by menu operations.
This inhibitions apply for the following control blocks.
• Cross-point control block
• Transition control block
• Independent key transition control block
1)
1) Only when the Key1, 2 or Key 3, 4 are assigned by the Compact Key Module Assign menu.
Knob Parameter Adjustment Setting values
1 Device
Function
Selection of device or
function to be assigned
1 and upwards
To Next Page
Loading...
Need help?
General