Chapter 19 Control Panel Setup (Panel)
1143
Overall Control Panel Settings (Config Menu)
6
Press [Set] yo confirm the setting.
This assigns the menu or action selected in the list to the button.
To cancel an assignment, select the button, then press [Clear].
To return all button assignments to the factory default state, in the Menu
Panel menu, press [Default].
Assigning Functions to the Buttons in the Multifunction
Flexi Pad Control Block
You can assign functions to the buttons in the various parts of the
Multifunction Flexi Pad control block in the following menus.
Mode selection buttons: Multi Function Module menu
Region selection buttons: 10 Key Region Assign menu
Memory recall buttons: Multi Function Module menu
For details of the Multifunction Flexi Pad control block, see “Multifunction
Flexi Pad Control Block” in Chapter 2 (Volume 1).
For details of assignment of regions to the region selection buttons, see
“Assigning a Region to the Region Selection Buttons in the Numeric Keypad
Control Block or Multifunction Flexi Pad Control Block” (page 1126).
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Multi Function Module].
The Multi Function Module menu appears.
3
Press one of the following three buttons displayed in the button area.
[Mode Sel Assign] button: To assign a function to the mode selection
buttons
[Eff Edit Assign] button: To assign a function to a button in the memory
recall section for effect editing (when the [EFF] and [EDIT ENBL]
buttons are pressed)
[Macro Edit Assign] button: To assign a function to a button in the
memory recall section for macro editing (when the [MCRO] and
[EDIT ENBL] buttons are pressed)
The left side of the status area shows an image of each button, and the right
side shows a list of menus and actions to be assigned.
4
In the button indications on the left, press the button for the assignment.
To Next Page
Loading...
Need help?
General