Chapter 19 Control Panel Setup (Panel)
1184
Interfacing With External Devices (Device Interface Menu)
Serial Tally: Use the SCU editor panel port for the serial tally.
Editor Keyboard: Use the SCU editor panel port for the editing keyboard.
Making DCU Serial Port Settings
You can assign buttons in the device control block (DEV1 to DEV12) to DCU
serial ports, to operate the devices (disk recorder/VTR/Extended VTR)
connected to these ports. For a disk recorder/Extended VTR, you can also set
the sharing of file lists.
For details of DCU serial port settings, see “Serial Port Settings (Serial Port
Assign Menu)” (page 1276).
Associating a serial port with a device selection button
1
In the Panel >Device Interface menu, press [DCU Serial Port Assign].
The Serial Port Assign menu appears.
2
Using any of the following methods, select the DCU serial port.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) The range of the setting value depends on the DCU port settings.
The DCU number, slot number, and serial port number appear.
3
Select the device selection button to be assigned from the <Assign> group.
Notes
• It is not possible to assign more than one device selection button to the
same port. The later assigned device selection button takes priority, and
the previous selection is invalidated.
• If P-Bus/Mixer ESAM-II is assigned to a serial port, it is not possible to
assign a device selection button to that port.
4
Repeat steps 2 and 3 as required to make assignments to other ports.
Knob Parameter Adjustment Setting values
1 No Serial port selection
1 and upwards
a)
To Next Page
Loading...
Need help?
General