Chapter 19 Control Panel Setup (Panel)
1129
Overall Control Panel Settings (Config Menu)
This clears the assignment of the selected region.
Setting the region selection buttons selected when the [ALL]
button is pressed
1
In the Panel >Config >10 Key Region Assign menu, press [All Select] in
the button area, or the [All Select] button indication in the status area,
setting it to On.
The [All Select] button indication in the status area changes to orange, and
the system switches to a mode for assigning region selection buttons to the
[ALL] button. In the factory default state, all buttons appear in reverse
video, and are assigned to the [ALL] button.
2
If you do not want to assign any region selection button to the [ALL]
button, press the corresponding button indication, setting it to Off.
The button you pressed returns to normal display.
Notes
Assignment to the [ALL] button is region by region. Changing the assignment
of a region selection button does not change the regions assigned to the [ALL]
button.
Setting the Assignment of Transition Type Selection
Buttons
You can change the assignment of transition type selection buttons in the
transition control block.
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Transition Module].
The Transition Module menu appears.
3
Select the bank of the transition control block you want to set in the <Bank
Select> group.
The current assignment of the transition type selection buttons appears at
the upper left.
To Next Page
Loading...
Need help?
General