Chapter 20 Switcher Setup (Switcher)
1251
Interfacing With External Devices (Device Interface Menu)
• Turn the knob.
Notes
• When using the MVE-8000A, it is not possible to select any of DME 1
Ext In to DME 8 Ext In.
• When using the MVE-9000 through the DME dedicated interface, it is
not possible to select DME 1 to DME 8 (video/key).
4
In the <Select> group, select the AUX bus or reentry to be assigned to the
DME channel.
Aux Bus: Set AUX bus.
Re-Entry: Set reentry.
5
Depending on the selection in step 4, use any of the following methods to
make the setting.
• Press directly on the list on the right of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
– When Aux Bus is selected
– When Re-Entry is selected
6
Press [Set].
In the list on the right of the status area, the selected content is reflected in
the specified DME channel.
Repeat steps 3 to 6 as required.
Selecting the Mode for Turning Off Keys Upon
Receiving the Editor Command
Selects the mode for turning off keys when an “All Stop” command is received
from the editor.
Knob Parameter Adjustment Setting values
1 DME Ch No DME channel selection 1 to 24
Knob Parameter Adjustment Setting values
2 Src No AUX bus number 0 to 48
Knob Parameter Adjustment Setting values
2 Src No Reentry number 0 to 80
To Next Page
Loading...
Need help?
General