Chapter 3 Signal Selection and Transitions
150
Signal Selection
a) Dual background bus mode (see below) can be selected.
Dual background bus mode
In this mode, the shifted signal on the background A row can be selected on the
key 1 row, and the shifted signal on the background B row can be selected on
the key 2 row.
To switch this mode on and off, it is necessary to assign this function to the
[PRE MCRO] button in the cross-point control block.
For details of the assignment operation, see “Overall Control Panel Settings
(Config Menu)” in Chapter 19 (Volume 3).
Notes
For the following switcher banks, dual background bus mode is not available.
• When set to “Dual M/E Assign”
• When M/E Config is set to “DSK”
AUX Panel-less Function
When using 24-column cross-point control blocks for the CCP-6224/CCP-
6324 Control Panel, you can use the key 1 and key 2 rows as the auxiliary bus
control block. This is called the panel-less function.
Preparations
Assign the function for switching to the AUX control mode to the [PRE
MCRO] and [POST MCRO] buttons. Hereafter this button is called the [AUX
CTRL] button.
In the source name display you can display either the source name or the bus
name.
For details of how to make the assignment, see Chapter 19 “Control Panel
Setup (Panel)” (Volume 3).
Selecting the AUX bus
1
Switch the operation mode with the [AUX CTRL] button.
2
In the key 1 row, select the AUX bus for the operation.
3
In the key 2 row, select the desired signal.
To Next Page
Loading...
Need help?
General