Chapter 18 System Setup (System)
1111
System Maintenance (Maintenance Menu)
Notes
When the hard disk is operating normally, pressing [HDD Format] has no
effect.
An initialization confirmation message appears.
2
To execute the initialization operation, press [Yes]. To cancel, press [No].
If you have pressed [Yes], the hard disk initialization operation is
executed, and a finished message appears. If you have pressed [No], the
initialization operation is canceled, and the System >Maintenance menu
appears again.
3
Press [OK].
The processor is reset.
Locking the Setup Menu Settings
To protect the data, you can inhibit operations in selected setup menus. Use the
following procedure. (It is not possible to lock the Setup Operation Lock
menu.)
1
In the System >Maintenance menu, press [Setup Operation Lock].
The Setup Operation Lock menu appears.
2
In the <VF Group> group, select the group including the desired menu.
The status area shows a list of menu numbers and menu names in the
selected group.
Subsequent lock operations apply within the group selected here.
3
Using any of the following methods, select the menu or the set of menus
as candidates for the locking operation.
• Press directly on the list in the status area.
• Use the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
• To select all setup menus within the selected group, press [ALL].
Knob Parameter Adjustment Setting values
1 No Selection of a menu by its number
in the list
1 and upwards
3 Num Selection of number of menus in
the list
1 and upwards
To Next Page
Loading...
Need help?
General