Chapter 19 Control Panel Setup (Panel)
1160
Auxiliary Bus Control Block Settings (Aux Assign Menu)
Auxiliary Bus Control Block Settings (Aux
Assign Menu)
To carry out the settings of the AUX delegation buttons in the auxiliary bus
control block, use the Panel >Aux Assign menu.
When using the AUX panel-less function with the CCP-6224/6324, use this
menu to assign the AUX delegation buttons.
To display the Aux Assign menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF3 ‘Aux Assign.’
The left side of the status area shows the delegation numbers, and the list of
buses set; the right side shows a list of buses that can be assigned.
The following functions are available here.
• Aux Assign: Assign the AUX delegation buttons in the auxiliary bus control
block to any bus.
• Shift Mode: Specify whether the rightmost button of the AUX delegation
buttons is used as a shift button, and when it is used as a shift button, the
operation mode.
• RTR Mode Setting: Carry out the following settings for using the auxiliary
bus control block for router control.
– Assigning destinations
– Setting the shift operation in the destination selection button rows
– Source table settings
– Setting the shift operation in the source selection button rows
– Assigning levels to the level selection buttons
– Setting destination selection buttons to be used for snapshots
Notes
When using the AUX panel-less function with the CCP-6224/6324, these
settings are invalid.
Assigning a Bus to an AUX Delegation Button
1
In the Panel >Aux Assign menu, using any of the following methods,
select the delegation button and the bus to be assigned.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
To Next Page
Loading...
Need help?
General